[Author Index]
[Date Index]
[Thread Index]
[Date Prev][Date Next][Thread Prev][Thread Next]
RE: Rookie chain adjustment question
- Subject: RE: Rookie chain adjustment question
- From: Erik Miner <axeis@xxxxxxxxxxxxxx>
- Date: Fri, 10 Dec 1999 07:29:06 -0500
Thanks Paul.
>Erik,
>
>I think you are spot on 35-40mm (1.37-1.57") 55nm torque (40ftlb). One very
>slight caution. Chain deflection should be measured at the 'tightest' point.
>If you tighten the chain slightly first it is easier to find the point with
>the least slack.
>
>Paul & Dee
> > spec for chain deflection, 35-40mm measured at the mid point between
> > the sprockets. The best way I found to measure the defection was to
> > take my tape measure put it on the floor. Take the metal end and put
> > it on the top of the chain push down on chain slightly and get a base
> > line number lets say 25. Keeping the chain in the EXACT same spot
> > push up on the chain, firmly, getting a new measurement. This
> > measurement after adjusting is 37mm greater than the base line
> > number. Now rotate wheel re-measure ( comes up the same) and tighten
> > bolt to 55nm as specified. Did I do it right?? I believe that I how
> > have the correct deflection on the chain.. do I ??
> >
> > TIA,
> >
> > Erik
>
>
> * * * * * * * * * * * * * * * * * * *
> The ST Mailing list is sponsored by the Unofficial ST Website
> http://www.TriumphNet.com/st for ST and Mailing List info
* * * * * * * * * * * * * * * * * * *
The ST Mailing list is sponsored by the Unofficial ST Website
http://www.TriumphNet.com/st for ST and Mailing List info
=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=