RE: KEY issues

["Retherford, Martin" <MRetherford@xxxxxxxxxxx>]

Folks,
	Try removing the plastic off of the key.  An old soldering iron and
some bad smell and it should come right off.  Maybe some aid with a sharp
knife.  Then take it back to the key smith and he should be able to come up
with something.

Martin

		-----Original Message-----
		From:	Archer, Doug [mailto:DArcher@xxxxxxxxxxxxxxx]
		Sent:	Tuesday, September 14, 1999 4:50 PM
		To:	'ST@xxxxxxxxxxxxxx'
		Subject:	RE: KEY issues

		I went through trying to find a plain key as well, no luck.
		The locks are made by Zadi, but their blanks also have
		plastic heads.
		Even more irritating is the fact that because the volume
		required for the blank is so low, the importer of Zadi
		blanks won't bring any into Australia.
		 
		On note of caution:  Triumph did a running change to
		the key blanks, so there is 2 possible key types that
		you could have.  They both have the same part no....
		 
		1st one I got supplied was wrong, but got it on the 2nd
		try.
		 
		Later  .. Doug
		 

		 *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
*   *   *   *
		 The ST Mailing list is sponsored by the Unofficial ST
Website
		   http://www.TriumphNet.com/st for ST and Mailing List info

 *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
 The ST Mailing list is sponsored by the Unofficial ST Website
   http://www.TriumphNet.com/st for ST and Mailing List info

=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=