Re: 3M Film

["Keith Winter" <kwinter@xxxxxxxxxxxxx>]

On 17 Feb 00, at 9:33, Eric Sheley wrote:

> Eric wrote:

> The film goes on wet and the air bubbles are squeegeed out (using the 
> supplied squeegee). If you look at the ST site under the accessories, you 
> will see (or not) the tank protector that I made for my ST. It has several 
> complex curves and would be impossible to do with a conventional clear film 
> (like would be used on dirt bikes etc). It took a little while and required 
> the use of a heat gun to soften the film a little, but it looks great. In 
> the kit I have a template for the one I used, but recommend cutting it down 
> a little to make it easier to install. It does not set immediately so it is 
> possible to put it down and then pull it back off to reposition it.

How difficult is it to remove after it is set?  Is it removable after it it 
set?  I'd want the option of being able to remove and replace it 
when it gets scuffed.

> I will put the info out about the kit that I offer, later today and if we 
> get enough interest, I will do another bulk order.

Please do; I'd like to take a look at it.

- -Keith
'00 Sprint RS
'98 CB750


     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info

=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=