[Author Index]
[Date Index]
[Thread Index]
[Date Prev][Date Next][Thread Prev][Thread Next]
Re: Front fork/ wheel question
- Subject: Re: Front fork/ wheel question
- From: Eric Sheley <eric@xxxxxxxxxx>
- Date: Mon, 20 Mar 2000 16:31:19 -0500
>Erik Miner wrote:
> > Is there a correct sequence for torquing the wheel bolts?? I'm
> > assuming tighten axle bolt than the pinch bolts is this correct??
At 04:16 PM 3/20/00 -0500, Robb N. Wong wrote:
>I'd have to say "no" that's not correct. Tighten your axle bolt within
>torque specs. Overtightening the axlebolt could lead to bound forks or
I think Erik meant "then" as in what order, not "than" as in tighten one
more than the other.
The torque values are listed in the FAQ section on the site - torque axle
to 61Nm - pinch bolts to 20Nm
- - Eric
* * * * * * * * * * * * * * * * * * *
The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
http://www.TriumphNet.com/st/lilley for more info
http://www.TriumphNet.com/st for ST, RS and Mailing List info
=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=