Re: Fuel Economy and top rack removal

[mfay@xxxxxxxxx (Martin Fay)]

I decided I was going to take another listers recommendation and weld the 
nuts to the bottom of the strengthening plate.
     
     I think that was me. I welded the nuts to the bottom of the 
     strengthening plate and removed the thread from the mounting points in 
     the frame. I then replaced the bolts with good quality stainless 
     items. This route meant that I can use a ratchet arm and socket from 
     above rather than using a spanner from below (I'm REALLY lazy). 
     There's not much room for swinging a spanner under the rack when the 
     alarm is fitted.
     
     Martin


**************************************************************** 
The information transmitted in this email is intended for the 
addressee only and may contain confidential and/or privileged 
material. Any review, retransmission,dissemination,reliance
upon or other use of, this information by persons or entities 
other than the addressee is prohibited.If you received this 
in error, please contact the sender and delete the material.
     
This message has been swept by Anti-Virus software 
****************************************************************

     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info

=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=