[ST] RE: (ST) Dead Trumpet

[mfay@xxxxxxxxx (Martin Fay)]

On the subject of disabling the safety cutout switches on the ST with a view to
eliminating a potential failure point might I suggest the following course of
action.

Instead of disconnecting the switches and shorting the wires together why not
cut the wires and rejoin them with waterproof bullet connectors but put one male
and one female connector on each side of the resulting wiring (switch and
harness sides). This way you can leave the switch in place but if it should fail
you simply disconnect the switch and connect the male and female connectors on
the harness side together then drive off.

FWIW,
Martin


**************************************************************** 
The information transmitted in this email is intended for the 
addressee only and may contain confidential and/or privileged 
material. Any review, retransmission,dissemination,reliance
upon or other use of, this information by persons or entities 
other than the addressee is prohibited.If you received this 
in error, please contact the sender and delete the material.
     
This message has been swept by Anti-Virus software 
****************************************************************

     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info

=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=