[no subject]

1. disconnect Battery
2. Drain engine oil
3. Remove Clutch cover
4. Lever out the Balance shaft plug without damaging the cases
5. Discard said plug
6. Turn engine over until the T1 mark on the Crankshaft rotor aligns with
the center of the crankshaft position sensor
7. The Markings on the Balance shaft should align with the pointers on the
outside of the casing.
8. fit a NEW plug
9. reverse procedure.

If the markings do not line up, the engine must be removed and the cases
split in order to remove and reposition the balance shaft.

Dan Wallander


Laters,
Brian
- --
'99 ST (black)
Dallas, TX

     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
*
      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info


     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info

=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=

End of st-digest V2002 #382
***************************


 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

                      End of Triumph ST/RS Digest
            ST/RS Digest is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info

          This digest Copyright 1999-2002 TriumphNet.com