[Author Index]
[Date Index]
[Thread Index]
[Date Prev][Date Next][Thread Prev][Thread Next]
RE: [ST] Re: 19mm
> >
> >...I use a 3/8" drive spark plug wrench (has an
> appropriately sized hex on
> >the top); invert it - put the extension in through the
> socket - and works
> >like a charm.
> >
> >MUCH cheaper and more useful than a 19mm hex...
>
>
Yes, but finding the tool was an adventure in itself!
RE: the front calipers, IIRC, mine are attached using a fairly standard
socket size (9 or 10 mm?). I've seen quite a few torx bolts around the bike,
but I've gone to those places infrequently (I think there were a couple when
I installed the rear hugger).
Maybe they were out of torx bolts in Hinkley when they put mine together and
just dug up a couple of others so they could get one more unit out the door.
:-)
Peter Chittum - '01 BRG Sprint ST
San Jose, CA, USA
* * * * * * * * * * * * * * * * * * *
The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
http://www.TriumphNet.com/st/lilley for more info
http://www.TriumphNet.com/st for ST, RS and Mailing List info
=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
End of st-digest V2002 #932
***************************
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
End of Triumph ST/RS Digest
ST/RS Digest is sponsored by Jack Lilley Ltd.
http://www.TriumphNet.com/st/lilley for more info
http://www.TriumphNet.com/st for ST, RS and Mailing List info
This digest Copyright 1999-2002 TriumphNet.com