[Author Index]
[Date Index]
[Thread Index]
[Date Prev][Date Next][Thread Prev][Thread Next]
Re: [ST] Re:19mm
- Subject: Re: [ST] Re:19mm
- From: "Albert Garvin" <agarvin@xxxxxxxxxxxxx>
- Date: Thu, 17 Apr 2003 18:31:47 -0700
Here is another simple solution. Get a standard 1/2" American SAE bolt about
2" long. The head size is 3/4" or 19MM. Now you can drill a 1/4" hole in the
theaded end and stick a phillips screwdrive through the hole for a T-handle.
Stick the hex head into the spindle to remove it. Or you can get two nuts
and double nut it using locktite and just use a 3/4" socket and ratchet.
Al
- ----- Original Message -----
From: <peter.chittum@xxxxxxxxxxxx>
To: <ST@xxxxxxxxxxxxxx>
Sent: Thursday, April 17, 2003 2:12 PM
Subject: RE: [ST] Re:19mm
>
> The wheel spindle is the funky-fresh
> 19mm-female-insert-your-hex-wrench-here-and-grunt-as-you-twist
thingamabobby
> (that, of course, being the technical term).
>
* * * * * * * * * * * * * * * * * * *
The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
http://www.TriumphNet.com/st/lilley for more info
http://www.TriumphNet.com/st for ST, RS and Mailing List info
=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
End of st-digest V2002 #934
***************************
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
End of Triumph ST/RS Digest
ST/RS Digest is sponsored by Jack Lilley Ltd.
http://www.TriumphNet.com/st/lilley for more info
http://www.TriumphNet.com/st for ST, RS and Mailing List info
This digest Copyright 1999-2002 TriumphNet.com