[Author Index]
[Date Index]
[Thread Index]
[Date Prev][Date Next][Thread Prev][Thread Next]
Re: [ST] front axle bolt size?
- Subject: Re: [ST] front axle bolt size?
- From: Bil Swartz <bil@xxxxxxxxxx>
- Date: Wed, 21 May 2003 16:53:45 -0400 (EDT)
On Wed, 21 May 2003, Dave wrote:
> The 01 uses a 19 mm Allen for the front axle. I used two 19 mm nuts
> welded together, since I had no allen that large.
> The 01 also uses 13 mm bolts for mounting the front calipers.
> Torque for the front axle -- 45 ft lbs [ 61 Nm]
> Torque for the front and rear caliper mounting bolts -- 29.5 ft lbs [
> 40 Nm]
> Torque for the front axle clamp bolts -- 14.76 ft lbs [20 Nm]
> My Haynes manual is for '97 thru '00 (source for the torque readings)
Thanks Dave, looks like the torque ratings are all the same as my 99 then.
Appreciate the info,
- --
._O_. '99 SprintST -mine
-Bil- /_\o/_\ '98 VFR800FI -hers /~\
"No I don't want a pickle..." /H\ '89 Hawk GT -ours ASCII \ / Against
bil@xxxxxxxxxx (=O=) AMA, CMH-Moto, Ribbon X HTML
"Drink Real Ale" "Quch!" #3 U DoD(6.66), HSTA! Campaign / \ Mail
* * * * * * * * * * * * * * * * * * *
The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
http://www.TriumphNet.com/st/lilley for more info
http://www.TriumphNet.com/st for ST, RS and Mailing List info
=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=