[Author Index]
[Date Index]
[Thread Index]
[Date Prev][Date Next][Thread Prev][Thread Next]
Re: [ST] Fitting the Ohlins.
- Subject: Re: [ST] Fitting the Ohlins.
- From: "Jim Schroeder" <jim.schroeder@xxxxxxxxxxx>
- Date: Fri, 21 May 2004 05:04:40 -0700
Had the same experience Simon...any IDEAS how to adjust compression damping
without lifting the stupid tank again??
Jim Schroeder
Desert Dawg
'99 Sprint ST (Sable)
> Well that was fairly painless. Looks nice as well.
>
> All I had to do was:-
> 1. Wedge a piece of wood under the rear wheel.
> 2. Remove the tank.
> 3. Undo the top and bottom shock retaining bolts.
> 4. Remove the bottom bolt.
> 5. Remove the top bolt and pull the shock out.
> 6. Slide the new shock in.
> 7. Inert top bolt
> 8. Insert bottom bolt, tap wedge under rear wheel to slightly raise wheel
to
> allow bolt to slide in.
> 9. Do up top and bottom shock retaining bolts. Two and a half grunts on
each
> bolt to make sure they are tight.
> 10. Replace tank.
>
> Very easy...
>
> --
> SimonB - South Wales.
>
> * * * * * * * * * * * * * * * * * *
*
> The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
> http://www.TriumphNet.com/st/lilley for more info
> http://www.TriumphNet.com/st for ST, RS and Mailing List info
>
* * * * * * * * * * * * * * * * * * *
The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
http://www.TriumphNet.com/st/lilley for more info
http://www.TriumphNet.com/st for ST, RS and Mailing List info
=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=