[ST] Oil Pressure Warning Switch

[Agate47@xxxxxxx]

Rupert,

Per the Shop Manual:

1. Remove the seat and disconnect the battery ground wire first.

2. Remove the electrical connector from the switch.  (The switch is located 
behind the cylinders on the right side, just inboard and ahead of the bracket 
that supports the end of the clutch cable.)

3. Remove the switch and collect the copper washers.


Install:

1. Using New copper washers, fit the switch and tighten to 13 Nm. 

2. Refit the electrical connector.

3.  Reconnect the batttery, positive lead first.

Ta!  Ta!  You are done.

I hope this helps.

Steve Knudsen
'00 RS
Auburn, WA

     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info

=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=