RE: [ST] Valve spec assistance needed 02 Sprint ST

["David Pullen" <dpullen@xxxxxxxxxxx>]

As my old physics professor used to say, "Units are your friends."

Besides, what else would you expect our metric-thinking brothers from across
the pond to use?  ;)  They even spell things strangely (colour, tyre,
etc.)...

  - Dave

- -----Original Message-----
From: owner-st@xxxxxxxxxx [mailto:owner-st@xxxxxxxxxx] On Behalf Of Justin
Sent: Sunday, September 26, 2004 2:02 PM
To: ST@xxxxxxxxxxxxxx
Subject: Re: [ST] Valve spec assistance needed 02 Sprint ST

On 9/26/04 6:18 AM, "David Pullen" <dpullen@xxxxxxxxxxx> wrote:

> My '02 and later service manual says 0.10-0.20mm intake, and 
> 0.20-0.30mm exhaust.
> 
> - Dave

Dave, 

    Thanks for the reply and the virtual thump to the head. It never really
dawned on me until I read your reply that I was using the wrong unit of
measure. I just couldn¹t figure out why all my valves were consistent to
each other but would have been so far out of range.

    Intakes were at .007in(.178mm)
    Exhaust were at .010in(.254mm)

Justin


     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
*
      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info




     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info

=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=