[Author Index] [Date Index] [Thread Index]
[Date Prev][Date Next][Thread Prev][Thread Next]

Re: [ST] Temp sensor woes



Andrew

If it's like the airbox temperature plug that I just removed, there is
a wire spring round three sides of the part that comes off.  You will
see it holds two latches in the plastic so either wiggle and pull or put
a finger nail under the end of the wire to lift it while you pull. 
Don't break your nails though!

Chris Harwood

00 RS

>>> antait@xxxxxxxxxxxxxxxx 12/05/2005 18:34:08 >>>
Hi all,

I'm doing a good run this weekend, and if the weather stays as it is 
just now it's going to be a stoater.

Anyway, I've done various bits'n'bobs to the bike this week in 
preparation, and last night thought I'd change the coolant.  Drained
and 
flushed and flushed and flushed and refilled it, but now I'm getting 
zero reading on the temperature gauge.  It's sitting hard against the 
needle.  Since not long after I got the ST 3 years ago every once in 
awhile I would see this happen, but it only took about a minute of 
riding to pop back into life.  Now nothing.

Anything I should be checking?  Does anyone know which part of the 
sensor connector unplugs and how to remove it?  Looking at it from the

side, there's a 'big' part to the connector with a metal spring clip, 
and a smaller part at the rear which is just clipped on.  It could just

be a little corroded I suppose, so I'd like to take it off and give it
a 
clean-up.

Thanks!

Andrew
_______________________________________________
Triumph Sprint ST/RS mailing list
Send list posts to ST@xxxxxxxxxxxxxx 
Change your list options at www.Triumphnet.com
_______________________________________________
Triumph Sprint ST/RS mailing list
Send list posts to ST@xxxxxxxxxxxxxx
Change your list options at www.Triumphnet.com