Re: [ST] Throttlemeister & Yriumph heated grips......

[George K <gkeslin@xxxxxxxxxxx>]

Thanks gentlemen!  I now have a working Throttlemeister installed.  I'll 
be heading out to test it in a few minutes.

George


Matthew Heyer wrote:
> Agreed - when I had the throttle meister on my old ST with heated grips, and simply replaced the bar end and used the right number of washers, and it worked.  That's all you need to do.
>  
> Matt Heyer
>
>
> ----- Original Message ----
> From: Bil Swartz <bil@xxxxxxxxxx>
> To: ST@xxxxxxxxxxxxxx
> Sent: Tuesday, May 16, 2006 5:59:07 PM
> Subject: Re: [ST] Throttlemeister & Yriumph heated grips......
>
>
> On Tue, 16 May 2006, George K wrote:
>
>   
>> I searched the archives and didn't find an answer to my question so.......
>>
>> I finally got around to buying a Throttlemeister and am trying to
>> install it on my 2002 ST.  I have factory heated grips installed
>> already.  If I follow the instructions it says to "rollback" the
>> throttle side grip about and inch and put their collar in.  It appears
>> to me that grip can't be rolled back without damaging it.  Does the
>> collar need to be inserted?  Am I doing something wrong or just being
>> stupid?  Any suggestions or tips?
>>     
>
> I don't remember needing the friction sleeve from the ThrottleMeister kit 
> with the heated grips George.  Take your bar end weight off and take a 
> look at the end of the grip and see if you see any black rubber there. 
> IIRC, there is plenty of friction available to the TM w/o that collar.
>
>   

_______________________________________________
Triumph Sprint ST/RS mailing list
Send list posts to ST@xxxxxxxxxxxxxx
Change your list options at www.Triumphnet.com