Re: Graphically challenged

[Eric Sheley <eric@xxxxxxxxxx>]

I would assume that you are referring to the piece that would be used as
the "normal" tank protector to protect where your jacket would rub on the
tank. Imagine that piece as half (cut down the middle) of a fat "Y". The
piece was too big to copy, so I cut it in half. To construct the
appropriate piece, lay it on a larger piece of paper, trace around the edge
and then flip it over and trace it on the other side.

As I noted in the instructions, the piece in that size is a challenging
install. I would recommend making it a little narrower and a little shorter
from the top. If you would like, I will outline the piece on my bike and
email the picture to give you a better idea of its orientation

Hope dat helps

- - Eric

Lance wrote,

>Help!  ---- mostly, Eric -- Help!
>
>
>I knew I was going to have problems when I failed at "where's Wally" in
>school, so I'm going to have to give up and tell you (any of you), that as I
>am in the process of installing the 3M invincashield from the templates that
>Eric sent, I haven't got a clue as to the one template that looks like a
>'fat gun' (probably a poor representation).  I've figured out the tank
>templates, the front of the lower fairing templates, etc, but this 'mystery'
>piece has me completely flummoxed.
>
>I bow to your aesthetic skills ---- please tell me where this piece goes
>(and if there is a right and left --- I'm assuming so).
>
>Graphically challenged yours,   Lance LaCerte


 *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
 The ST Mailing list is sponsored by the Unofficial ST Website
   http://www.TriumphNet.com/st for ST and Mailing List info

=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=