[Author Index]
[Date Index]
[Thread Index]
[Date Prev][Date Next][Thread Prev][Thread Next]
Re: Rear Hugger installation - an observation
- Subject: Re: Rear Hugger installation - an observation
- From: Eric Sheley <eric@xxxxxxxxxx>
- Date: Sat, 27 Nov 1999 22:10:28 -0500
At 07:37 PM 11/27/1999 -0600, Jeff Jenkins wrote:
>get it on my '99 ST. Noticed something with my bike though, the hole the
>right side was supposed to be attached to has something in it, a bolt or
>similar serious looking metal bit. It looks like it will be secure without
>mounting that right side but should I perservere in getting that hole open?
If you are talking about the hole in the swingarm, it should have a plastic
blanking plug installed in the hole to keep sand etc out of the threads.
When you install the hugger, you should remove the plug and bolt the hugger
at that point.
- - Eric
* * * * * * * * * * * * * * * * * * *
The ST Mailing list is sponsored by the Unofficial ST Website
http://www.TriumphNet.com/st for ST and Mailing List info
=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
End of st-digest V1999 #312
***************************
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
End of Triumph ST Digest
Digest sponsored by the Unofficial Triumph Sprint ST Website
http://www.TriumphNet.com/st for ST and Mailing List info
This digest Copyright 1999 TriumphNet.com