Re: RE: Heat Shield

[Eric Sheley <eric@xxxxxxxxxx>]

At 02:14 PM 09/23/1999 -0500, David Arnett wrote:
 >heat shield with a bunch of cuts in it with cement stuck to it.  I would
 >definately advise to make several cuts in the new piece so that it fits the
 >curves, but it also provides more edge area at which water and crap could

wouldn't these cuts / seams then provide an area for the heat to pass 
through to the fairing?

 >penetrate.  I would like to get a piece of "thin" shielding material without
 >the chicken-scat adhesive, and take my time cutting the little long
 >triangles out of it to make it fit perfectly with no overlapping material
 >and use a quality epoxy after roughing up the surface of the fairing so it
 >will stick.

well, if you come up with anything, please let me know.

- - Eric


 *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
 The ST Mailing list is sponsored by the Unofficial ST Website
   http://www.TriumphNet.com/st for ST and Mailing List info

=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=