[Author Index]
[Date Index]
[Thread Index]
[Date Prev][Date Next][Thread Prev][Thread Next]
RE: 3M Film
Eric,
are you going to place an bulk order for this 3M film in the near future? I´m very interested - is shipping to Europe also possible?
Thank you!
Thomas
- ----------
>
> > -----Original Message-----
> > From: owner-st@xxxxxxxxxx
> > [mailto:owner-st@xxxxxxxxxx]On Behalf Of Keith
> > Winter
> > Sent: Thursday, February 17, 2000 7:56 AM
> > To: ST@xxxxxxxxxxxxxx
> > Subject: Re: 3M Film
>
> > How difficult is it to remove after it is set? Is it
> > removable after it it set? I'd want the option of
> > being able to remove and replace it when it gets
> > scuffed.
>
> So far my film has been holding up much better than expected, so
> scuffing shouldn't be too much of a problem. If you should decide
> to remove it, it's not all that hard, even if it has been on there
> a while. I had a piece where the carbon tank pad goes for a few
> months and removed it without any special preparations at all -
> just pulled that bad boy off of there. It did come off in a couple
> of pieces, but it didn't leave any adhesive or harm the paint at
> all.
>
>
>
> * * * * * * * * * * * * * * * * * * *
> The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
> http://www.TriumphNet.com/st/lilley for more info
> http://www.TriumphNet.com/st for ST, RS and Mailing List info
>
* * * * * * * * * * * * * * * * * * *
The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
http://www.TriumphNet.com/st/lilley for more info
http://www.TriumphNet.com/st for ST, RS and Mailing List info
=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=