[Author Index] [Date Index] [Thread Index]
[Date Prev][Date Next][Thread Prev][Thread Next]

Re[2]: st-digest V2000 #64



     Rick,
     
     We haven't managed to produce anything satisfactory yet. Our last 
     effort didn't clamp the bracket tightly enough to satisfy either Derek 
     (The engineer) or myself. So, for the moment we're still using some 
     fabricated brackets to hold the nuts captive so that the hardware can 
     be removed in a few minutes without removing the tailpiece.
     
     We do have a few more ideas but they're on hold temporarily while I 
     move house. For the moment Derek is making the steel gates for my new 
     Garage but rest assured, as soon as the workshop is complete we'll be 
     spending evenings drinking cold beers and staring at the bracketry 
     searching for that final solution. :)
     
     Martin


______________________________ Reply Separator _________________________________
Subject: Re: st-digest V2000 #64
Author:  TXToday@xxxxxxx at Internet
Date:    26/02/00 14:02


Howlin' Dawg,
     
Did you figure out a way to 'quick release' the pannier bracket on the right?
     
Horn Dawg


**************************************************************** 
The information transmitted in this email is intended for the 
addressee only and may contain confidential and/or privileged 
material. Any review, retransmission,dissemination,reliance
upon or other use of, this information by persons or entities 
other than the addressee is prohibited.If you received this 
in error, please contact the sender and delete the material.
     
This message has been swept by Anti-Virus software 
****************************************************************

     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info

=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=