[Author Index]
[Date Index]
[Thread Index]
[Date Prev][Date Next][Thread Prev][Thread Next]
Re: Two Brothers Risers
- Subject: Re: Two Brothers Risers
- From: Thomas Emberson <thomas@xxxxxxx>
- Date: Thu, 23 Mar 2000 10:30:28 -0500
On Thu, 23 Mar 2000, Stephen E. Hale wrote:
> <<They look nice, expensive, but nice. Also I can't tell but I doubt
> they are drilled for heated grips although I don't think that would
> be too difficult or expensive to have done.>>
>
> I have a pair of the Two Brothers racing clip-ons on my Ducati racebike.
> There are nice (and expensive). Also, they are hollow so you can easily
> drill a hole or two to run the wiring for heated grips, I had to drill a
> couple of holes for tabs for lining up the controls on my Duc.
>
> One BIG warning I learned on Tuesday. Since the bars are adjustable for
> angle, DO NOT use them to tie down the bike. The bars likely will move and
> loosen your tiedowns causing horrendous (and expensive) side effects.
Damn, how much damage did you do? Bike and truck?
Thomas
/***************************************************
Thomas Emberson <Thomas@xxxxxxx>
QNX Software Systems Inc.
15301 Spectrum Drive, Suite 406, Addison TX, 75001
(972) 851-6945 (voice) (972) 851-6944 (fax)
****************************************************/
* * * * * * * * * * * * * * * * * * *
The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
http://www.TriumphNet.com/st/lilley for more info
http://www.TriumphNet.com/st for ST, RS and Mailing List info
=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=