Re: [ST] Another plug for Skyking Products.

["Mike Patzius" <zeusx4@xxxxxxx>]

When John was making the risers up he wanted to make sure that they would 
work for the ST as well as the RS.  The original bolts will be replaced by 
longer bolts, and the clipon will just slide over the bar riser John has 
made up.  The whole assembly will then fit over the top of your fork tube.  
If you have seen the GenMar's then you will get the idea, his however is a 
one piece bar riser.  Hopefully he will have some photos up on his website 
or will be viewing the message board here and then post some pics.  His 
website is www.skykingproducts.com, and I have seen the ST clipons.  The 
only difference I noticed between the RS and the ST is that the ST clipon is 
a little bit taller.


>From: Brian D <brd@xxxxxxx>
>Reply-To: ST@xxxxxxxxxxxxxx
>To: ST@xxxxxxxxxxxxxx
>Subject: Re: [ST] Another plug for Skyking Products.
>Date: Wed, 10 Jul 2002 17:01:15 -0500
>
>On Wed, Jul 10, 2002 at 01:07:44PM -0700, Mike Patzius wrote:
> > As some of you know I have been suppling the RS that has been the test
> > platform for the Sprint ST/RS Frame Sliders, Fender Eliminator/Indicator
> > Bracket and now the latest is Bar Risers.  John had an idea to create 
>some
> > bar risers that would be better than the ones made by Gen-mar, and I 
>think
> > he has done it.
>
>Cool!
>
> > I received the risers over the July 4 weekend and installed
> > them with no problems.  You remove the 2 screws that hold the bars down 
>and
> > loosen the pinch clamp bolt and remove the bar.  Slide the Riser over 
>the
> > fork tube, reverse the procedure above and there you have it.
>
>I'm not familiar with the RS clip-ons, so don't know if they're the same
>as the ST.  But I'm trying to visualize the set up.  So do the bars grip
>the top of the fork tube anymore?  Or does tightening the pinch-bolts
>actually do anything, or are the clip-ons just held on by the 2 bolts
>into the triple clamp now?
>
>Do you replace the screws with longer ones that go through the clip-on,
>riser, and into the original holes in the triple clamp?
>
>Most importantly, will they work on the ST?    :)
>
>Laters,
>Brian
>--
>'99 ST (black)
>Dallas, TX
>
>      *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   * 
>   *
>       The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
>           http://www.TriumphNet.com/st/lilley for more info
>    http://www.TriumphNet.com/st for ST, RS and Mailing List info




_________________________________________________________________
MSN Photos is the easiest way to share and print your photos: 
http://photos.msn.com/support/worldwide.aspx


     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info

=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=