[Author Index]
[Date Index]
[Thread Index]
[Date Prev][Date Next][Thread Prev][Thread Next]
re:[ST] Skyking Frame Sliders Comments
- Subject: re:[ST] Skyking Frame Sliders Comments
- From: "Peckham ." <peckhammer@xxxxxxxxxxx>
- Date: Fri, 17 May 2002 06:05:15 -0700
>From: "John King" <skykingskunkworks@xxxxxxxxxxx>
>I just had an opportunity to review your commnents and thank you very much
>for positive words on the design and instructions. We want all of you to be
>a life long customer. We are very proud of the design and glad to offer in
>made American product that is significantly less costly than the German
>sliders. With regard to your torque comments.....Triumph uses a M12 torx
>bolt with a 1.25p thread but if you take a closer look it is actually
>smaller dia in the unthreaded portion. Skykingproducts.com item 17 frame
>sliders utilize the same M12 size but a stud is used which is rated 120,000
>PSI tensile strength. The item 17 M12 stud uses a standard pitch for an M12
>which is 1.75. The standard torque setting for an M12 anything between 45
>and 62 pounds.
Thanks for your response John.
>If there are any volunteers that want to pitch their ST down at speed we
>will be happy to supply the sliders at no charge :)
I now have an excuse next time I wad!
>--
Peckham
_________________________________________________________________
Send and receive Hotmail on your mobile device: http://mobile.msn.com
* * * * * * * * * * * * * * * * * * *
The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
http://www.TriumphNet.com/st/lilley for more info
http://www.TriumphNet.com/st for ST, RS and Mailing List info
=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=