Re: [ST] switch templates

[al bailey <acb@xxxxxxx>]

Bil Swartz wrote:
> 
> Hey all, finally settled on using the nice lit rocker switch from
> Electrical Connection for my Kimpex grip heater installation.
> 
> It's a fairly large switch, I'm thinking similar to the OEM one so I'm
> looking to see if the mounting templates or any alternative ideas from
> someone who's done it are out there.
> 
> Also looking for info on the OEM heated grip connector under the dash,
> what kind of connector it is (so I can find a mate), what the pin out and
> capacity of the wires are, etc.

bill, if you're already set on the above rocker switch then
disregard this mail, but i seem to recall several listers
here in the states using the switch from the uk/euro version
to operate an accessory. available from lilley's for <$100
if i recall. not cheap, but a cool solution. you should be
able to find info in the archives.

also, please write up your install. it's one of those
upgrades on my todo list as well.

	good luck - al.
- -- 
       /\ _
      /  \ \    al bailey
     / /_ \ \ _  415.448.crud
    /_/  \_\___\  acb@xxxxxxx

     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info

=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=