Re: [ST] Clutch Cable

[Dennis Griffin <eagleeye@xxxxxxxxx>]

Thanks for taking the time to respond. Can you please tell me if your 
cable passes between the fork legs, and the triple clamps, or does it 
pass outside the right leg.

Thanks again,

Dennis

On Sunday, July 13, 2003, at 04:23  PM, 2000blueRS wrote:

> Mine is routed through the opening in the right side motor mount, 
> rearward
> behind the frame rail, then down to the fitting. The metal tube points 
> up
> and runs just behind the bodywork bracket.
>
> _________________
> Mike the Web Geek
> 1994 Ducati 900SP, 2001 Triumph RS
> Graphic Design, Editing, Web Design
> Owner/operator of
> www.minnesotasbookstore.com
> www.comm.media.state.mn.us/bookstore/centralmail/ (under development)
> www.comm.media.state.mn.us/
>
> ----- Original Message -----
> From: "Dennis Griffin" <eagleeye@xxxxxxxxx>
> To: <st@xxxxxxxxxxxxxx>
> Sent: Sunday, July 13, 2003 3:55 PM
> Subject: [ST] Clutch Cable
>
>
>> My '00 RS has a clutch cable that has a metal sweep L (~ 45°) at the
>> lower end where it attaches to the bracket. Would someone with this
>> same configuration please describe the cable routing and orientation 
>> of
>> that L bend, or maybe send me a picture? Mine seems to want to point
>> down before the cable goes back up, so that it passes under the 
>> Triumph
>> logo on the right side of the engine. Looks goofy. I tried routing it
>> with the bend pointing up, but there is so much cable that way that I
>> had to pass it outside the fork legs, and it didn't seem right that 
>> way
>> either. Looks like later models may have a straight cable, which must
>> be shorter.
>>
>> Thanks,
>>
>> Dennis
>> Scottsdale, AZ
>> '00 RS, miss me yellow

     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info

=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=