RE: [ST] Metal Fuel Fittings

["Masiak, Richard" <Richard_Masiak@xxxxxxxxxxxxxxxx>]

I came in on the tail end of this metal fitting discussion.  Although I
haven't had any problems, I never paid close attention to see if mine are
plastic or metal.

If mine are plastic & if the cost isn't too expensive, sure I'll join in on
the bulk buy.  Better to be safe than sorry.

Rich
'00 RS

- -----Original Message-----
From: colt4530@xxxxxxxxxxx [mailto:colt4530@xxxxxxxxxxx]
Sent: Monday, October 06, 2003 12:16 PM
To: ST@xxxxxxxxxxxxxx
Subject: RE: [ST] Metal Fuel Fittings


I bought a set of metal fuel fittings from a distributor in Nashville. 
They were the Colder Products fittings apparently sold by EZ-Flow.  They do
not have viton O-rings, but have Buna-N O-rings, rated as "excellent" for
gasoline service.

John Albright
'02 RS 
Chattanooga

     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info

=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=