RE: [ST] Grease your Balls!!!

["Masiak, Richard" <Richard_Masiak@xxxxxxxxxxxxxxxx>]

Gasoline would probably eat up the O-rings.  Kerosene and a grunge brush are
recommended by all my local shops.  If you're out of Kerosene I was told
that WD40 works just as good.

- -----Original Message-----
From: Centaurious [mailto:centaurious@xxxxxxxxx]
Sent: Monday, September 08, 2003 7:36 PM
To: ST@xxxxxxxxxxxxxx
Subject: [ST] Grease your Balls!!!


Hello, everyone, I was doing some cleaning and adjusting on my new ( to me )
01 ST and I found the
Shifter ends were full of white corrosion.  This was not dried lithium
grease either.
So...Grease Your Balls!  
 
What do you recomend for lubing the chain?

I am NOT going to replace the tar the previous owner/shop used.
I had to use gasoline to remove it, Simple Green would not touch it.


Best regards.	

Todd
01 Sprint ST in BRG
Pensacola
			 
centaurious@xxxxxxxxx
2003-09-08




     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
*
      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info

     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info

=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=