[Author Index] [Date Index] [Thread Index]
[Date Prev][Date Next][Thread Prev][Thread Next]

Re: [ST] RS problems....



Was the CO set correctly



At 12:49 AM 8/3/2004, you wrote:
>Confirm they put Tune 10130 in it.
>
>It is not supposed to have a vacuum line to the pressure regulator.
>
>Yours could be one of those on the low end of tolerance for fuel 
>pressure.  Does it have a K&N filter?  I've run into one RS that had a 
>pipe and filter and was grossly lean with the correct tune.  I helped it 
>by adding more fuel with Tuneboy.  I could cure it if the guy would bring 
>it back, but he is evidently happy enough with it.
>The bike has an O2 sensor.  It can do SOME adapting with that.
>
>JAU149@xxxxxxx wrote:
>
>>Well, I went and put on my brand new stainless race can today, and headed 
>>over to the dealer for what should have been the simple task of 
>>downloading a new appropriate tune. With the stock pipe, after the first 
>>few thousand miles, the bike would occasionally backfire, but nothing 
>>hampering performance.  ..... BUT, my bike has NO hose on the fuel 
>>pressure regulator....I looked and looked and looked for the other end, 
>>but it simply is not there, nor does it have a rollover valve...it simply 
>>has two drain tubes out of the tank. Its!
>>  a non-Cal 02 RS. Any thoughts, ideas, whathaveyou ?
>>
>>Thanks
>>
>>John
>>Pissed off in Cleveland....
>>
>
>--
>John Albright
>'02 RS
>'00 748
>Chattanooga
>C-RATs
>
>
>     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
>      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
>          http://www.TriumphNet.com/st/lilley for more info
>   http://www.TriumphNet.com/st for ST, RS and Mailing List info


     *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *   *
      The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
          http://www.TriumphNet.com/st/lilley for more info
   http://www.TriumphNet.com/st for ST, RS and Mailing List info

=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=