[Author Index]
[Date Index]
[Thread Index]
[Date Prev][Date Next][Thread Prev][Thread Next]
Re: [ST] Re: st-digest V2004 #603
- Subject: Re: [ST] Re: st-digest V2004 #603
- From: Mike Montville <mjmontville@xxxxxxxxx>
- Date: Mon, 8 Nov 2004 07:28:58 -0800 (PST)
Nancy,
RacTech's part number for the cartridge emulators is FEGV 4301.
I used their 0.9 Kg/mm springs for my 185 lbs. This is slightly
lighter than their spring rate calculator recommends, but it works
well here in the NE US where roads are less than smooth.
I used 15W Silkolene fork fluid, which also works well and doesn't
cost the small fortune that R/T gets for theirs.
Mike
- --- Nancy Henderson <marmots05@xxxxxxx> wrote:
> Which
> part number for the R/T emulators did those of you who have them
> use? The
> closest listing on the application chart was a 99' Sprint ST
> 900(?).
>
> Nancy in Portland
> 02' Triumph Sprint ST
> 95' Yamaha YZF600
> 88' Yamaha YSR50
>
> * * * * * * * * * * * * * * * *
> * * *
> The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
> http://www.TriumphNet.com/st/lilley for more info
> http://www.TriumphNet.com/st for ST, RS and Mailing List info
>
>
__________________________________
Do you Yahoo!?
Check out the new Yahoo! Front Page.
www.yahoo.com
* * * * * * * * * * * * * * * * * * *
The ST/RS Mailing list is sponsored by Jack Lilley Ltd.
http://www.TriumphNet.com/st/lilley for more info
http://www.TriumphNet.com/st for ST, RS and Mailing List info
=-=-=-= Next Message =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=