Re: [ST] Emergency motor install help

[JUSTIN SHREAVES <wyckoffjustin@xxxxxxxxx>]

I am pretty sure that if you get all the bolts through with the engine in, you will notice from looking and all the spots you will see that gap that it came from. I did the same thing with my engine swap, and noticed the one on the bottom left of my setup. Just get everything in, snug the bolts with no torque, and you should see the gap where it needs to go, since the other five spots will self center. Run the adjusters in to about where they were, not much further, and you should come out okay.
   
  Justin

triumph1 <triumph1@xxxxxxxxxxxxx> wrote:
  I am in the middle of replacing the motor on my RS and had everything 
marked carefully and while wrestling the motor back in the frame I took 
the mounting bolt apart and once I had them in realized I have a small 
washer/spacer left over and cannot tell from the manual where this 
friggin thing goes. Anyone that knows about the spacers in the mounts 
please email direct or post as quickly as you can. The washer/spacer is 
not the large aluminum one that goes on the right rear lower mount. It 
looks like a regular washer about a 1/2 to 3/4 in diameter.

Damning myself

Tim
_______________________________________________
Triumph Sprint ST/RS mailing list
Send list posts to ST@xxxxxxxxxxxxxx
Change your list options at www.Triumphnet.com


		
---------------------------------
Talk is cheap. Use Yahoo! Messenger to make PC-to-Phone calls.  Great rates starting at 1&cent;/min.
_______________________________________________
Triumph Sprint ST/RS mailing list
Send list posts to ST@xxxxxxxxxxxxxx
Change your list options at www.Triumphnet.com