Re: [ST] That's the connection

["Marc Van Est" <MarcVE@xxxxxxxxxxxxxx>]

That's brilliant!

I cant believe I didn't think of that -its much easier to solder a
decent connection off the bike, I didn't fancy trying to crimp something
onto the wiring harness without solder, and there's much space to work
with a soldering iron inside that fairing.


Cheers


marc 

-----Original Message-----
From: st-bounces@xxxxxxxxxxxxxxxxxxxx
[mailto:st-bounces@xxxxxxxxxxxxxxxxxxxx] On Behalf Of Jack Hays
Sent: Wednesday, July 19, 2006 7:07 PM
To: st-triumphnet.com@xxxxxxxxxxxxxxxxxxxx;
st-triumphnet.com@xxxxxxxxxxxxxxxxxxxx
Subject: [ST] That's the connection

Marc, why not just make a short jumper wire? Put the connectors you need
on each end and leave everything else alone?



Jack Hays
972-952-5065
"I'll see you on the dark side of the Moon"

_______________________________________________
Triumph Sprint ST/RS mailing list
Send list posts to ST@xxxxxxxxxxxxxx
Change your list options at www.Triumphnet.com


This email forms part of an electronic communication sent to the intended recipient or such persons authorised representative, for the recipients sole use and is subject to important legal and regulatory restrictions, qualifications and disclaimers ("Email Legal Notice") that must be accessed by clicking here http://www.foschini.co.za/disclaimer.htm or copy this address onto your Internet browser and process there.  The Email Legal Notice is enforceable and binding on the recipient (or such persons authorised representative) in terms of section 11 (1) to 11 (3) of the Electronic Communications and Transactions Act No. 25 of 2002. By receiving, reading or acting upon this email, you automatically be bound by the terms of the Email Legal Notice.

_______________________________________________
Triumph Sprint ST/RS mailing list
Send list posts to ST@xxxxxxxxxxxxxx
Change your list options at www.Triumphnet.com