Re: [St] Engine light, etc

[John Ulizzi <jaulizzi@xxxxxxxxxxxxx>]

Thanks Fred. Thats really strange, the "from 02 on"
manual clearly shows that hose and mentions it's
hookup, it just doesnt say where the other end
goes...I am pretty sure I did not miss any connectors,
so we'll see what happens when I put her back
together...

John


--- Frederic NIZERY
<frederic.nizery@xxxxxxxxxxxxxxxxx> wrote:

> Hi John
> 
> >From 02 on there's no hose from the fuel pressure
> regulation system.
> Regarding the MIL (light) I would wait for the three
> cycles patiently.
> Otherwise you may double check that you didn't miss
> some connectors while putting 
> things back together (air temp sensor, fuel gauge).
> 
> Fred
> 
> >Well I put my 02 RS back together again last night
> >after about 6 months. I took off the tank and air
> box
> >in October to work on my sticky throttle cables,
> and
> >just got back to it now. I started it and let it
> heat
> >......
> >they end up even with each other where they exit
> near
> >the bottom of the motor. So I am not sure if I am
> >correct or not. Is this causing my engine light? Or
> do
> >I just need to heat cycle a few times? Any advice
> >appreciated...
> 
> >Also, can anyone verify if Showa SS-8 fork oil is
> in
> >fact 10 wt oil?
> 
> >John ( with 2 out of 2 bikes out of service...)
> 
> 
> 
> 
> 
> 
> _______________________________________________
> Triumph Sprint ST/RS mailing list
> Send list posts to ST@xxxxxxxxxxxxxx
> Change your list options at www.Triumphnet.com
> 

_______________________________________________
Triumph Sprint ST/RS mailing list
Send list posts to ST@xxxxxxxxxxxxxx
Change your list options at www.Triumphnet.com